Fisher & Paykel Smartload DEGX1US Instrukcja Użytkownika

Installation instructionsDEGX1USElectric Dryer

Choose a route that will provide the straightest and most direct path outdoors. Plan the installation to use the fewest number of elbows and turns.Whe

Preferred 4” HoodsWhen you have a 4” (10cm) HoodMaximum length of 4” diameter metal duct.Number of 90˚ elbows/bendsRigidThick Wall Flexible Metal(full

Alternative installation for close clearancesVenting systems come in many varieties. Select the type best for your installation. A close-clearance ins

Exhaust venting WARNINGFire HazardUse heavy metal exhaust duct.Do not use a plastic exhaust duct.Do not use thin metal foil exhaust duct.Failure to d

InstallationParts and literature are packaged inside the dryer drum. WARNINGExcess Weight HazardUse two or more people to move and install the dryer.

Fitting the front feetNote: Dryer is usually supplied with feet fitted and protruding the correct distance.1. Tilt the dryer back using a hand trolley

Electrical requirements WARNINGElectric Shock HazardUse a new UL approved 30-ampere power cord or direct wire cable.Use a UL approved strain relief.D

WARNINGElectrical Shock HazardMake sure appliance is wired or plugged into a grounded outlet.Do not use an adaptor.Do not use an extension cord.Fail

Power supply cord requirements for U.S.A Only a UL listed power-supply cord kit at least 6ft (1.8m) long and rated 120/240 V min, 30 A and marked wi

Electrical connectionsPlease read Electrical requirements and grounding instructions on pages 16–18 first.The DEGX1 electric model of the SmartLoad™ d

Important safety instructions WARNINGTo reduce the risk of fire, electric shock, or injury to persons when using your appliance, follow basic precaut

3-wire connectionsFor use where local codes permit grounding through the Neutral wire.Use approved 3-wire Power Supply Cord or a 3-wire Cable for Dire

3-wire connections plus separate grounding connectorFor use where local codes do not permit grounding through the Neutral wire.Use approved 3-wire Pow

4-wire connectionsUse approved 4-wire Power Supply Cord or a 4-wire Cable for Direct Wiring as described on page 18.1. Remove the terminal block cover

Level machineCheck the dryer is level, and make necessary adjustments to the front levelling feet.The rear levelling feet are self adjusting.Final ins

Copyright Reserved © Fisher & Paykel 2004.The product specifications in this booklet apply to the specific products and models descr

Read this before you start installing your dryerThis is the safety alert symbol. This symbol alerts you to hazards that can kill or hurt you and other

To the installerThe correct installation of the dryer is your responsibility. Be sure you read the following instructions carefully before you start t

The area in which the dryer is located must be kept clear and free from combustible materials, gasoline and other flammable vapours and liquids. A dry

DimensionsLid clearanceCheck that there is enough clearance for the lid to fully open.        

Mobile home installationThe installation of the dryer in a mobile home must conform to the Manufactured Home Construction and Safety Standard Title 24

ExhaustingThe dryer must be exhausted to the outdoors. This will prevent the build up of lint and moisture in the room in which it is located and redu

To reduce condensation, insulate any ducting which passes through unheated areas. Slope the duct gently downwards to the hood, to drain condensation a