Fisher & Paykel DD36STI Instrukcja Użytkownika Pobierz pdf

Important!

SAVE THESE INSTRUCTIONS

The models shown in this document may not be available in all markets and are subject to change at any time. For current details about model and specification availability in your country, please visit our local

website listed at the end of this document or contact your local Fisher & Paykel dealer.

SAFETY AND WARNINGS

WARNING!

Electrical shock hazard

WARNING – To reduce the risk of electric shock, fire, or injury to persons, the

installer must ensure that the DishDrawer® is completely enclosed at the time of

installation.

Before fitting the front panel and connecting the integrated badge, make sure

that the DishDrawer® is completely enclosed by cabinetry, and disconnected from

the power supply.

The integrated badge must be electrically connected by a suitably qualified

installer.

Failure to follow these warnings may result in electrical shock, injury or fire.

WARNING!

Cut hazard

Take care - panel edges are sharp.

Failure to use caution could result in injury or cuts.

Important safety instructions!

Read these instructions completely and carefully.

Ensure the product is not plugged in.

Installation of DishDrawer® panels requires basic mechanical and electrical skills.

Installation must comply with your local building and electricity regulations.

Failure to install the Dishdrawer® panels correctly could invalidate any warranty or liability claims.

DishDrawer®

Front panel preparation (Integrated models only)

DD36STI, DD90S(H)TI models

US CA NZ AU GB IE

(1,1) -1- 590018A DD36SDD90S DoorPanelPrep USCANZGB.indd 22/2/10 1:49:22 PM

1 2 3 4 5 6 7 8

Podsumowanie treści

Strona 1 - SAFETY AND WARNINGS

Important! SAVE THESE INSTRUCTIONSThe models shown in this document may not be available in all markets and are subject to change at any time. For

Strona 2 - PANEL PREPARATION

The following calculations assume the top of the panel is aligned with the top of the adjacent cabinetry:width of the panelMeasure A (the width betwee

Strona 3 - PARTS SUPPLIED

PARTS SUPPLIEDZONE REQUIRED FOR BADGE REMOVE PANEL BRACKET & DETACH BADGE345Panel mounting screws (14)Supplied separately Attached to productInteg

Strona 4 - SECURE PANEL BRACKET TO PANEL

ROUTE BADGE THROUGH PANELRECONNECT BADGE REATTACH PANELSECURE PANEL BRACKET TO PANEL68971212⁄” (16 mm) x1412Electrical Shock HazardWARNING !Connect

Strona 5

If, after installation, the front panel of your DishDrawer is not correctly aligned with the front panels of surrounding cabinetry, it can be adjusted

Strona 6 - DISCONNECT FROM POWER SUPPLY

DETACH CONTROLS LOOSEN PANEL BRACKETSREMOVE FRONT PANEL4532DISCONNECT FROM POWER SUPPLYElectrical Shock HazardWARNING !Disconnect the DishDrawer from

Strona 7 - TIGHTEN PANEL BRACKETS

SLIDE BRACKETS TO SUITABLE HEIGHT SETTINGRECONNECT CONTROLS REATTACH PANELTIGHTEN PANEL BRACKETS689712Electrical Shock HazardWARNING !Connect the grou

Strona 8 - RECONNECT THE POWER SUPPLY

RECONNECT THE POWER SUPPLY10www. sherpaykel.com www. sherpaykel.ca www. sherpaykel.co.nz www. sherpaykel.com.au www. sherpaykel.co.uk www.